FLEISCHMANN TWIN-CENTER 6802 Handbuch Seite 91

6802_10_12_04_Handbuch_GB
3 Point Routes
Three groups of point routes, each with 16 routes,
can be entered into the TWIN-CENTER and cal-
led up again. The input and call up of a first "small
route" is demonstrated here.
Requirements
• TWIN-CENTER 6802 (with V1.100 softw.)
• TRAFO 6812 or 6811
• Electrical accessory receiver module
6852
• Point with electric motor
Programming Point Routes
• Press the [mode] key as required until
the TWIN-CENTER is in Memo mode.
You can also press [mode] and [1].
• Press the [menu] key
Memo:
Gr.-Nr.1
• Continue with the [→] key until the entry
"Prog"
• Confirm the selection with the [↵] key
Gr.-Nr.1
Route No. 1
• Confirm the point route number (here 1)
with the [↵] key
Gr 1 | Step VAdd RG
S01 |
• Confirm the first programm step (Step 0)
and continue with the [→] key
• Under "VAdd" column, enter the virtual
addresses of the points to be switched
• Press the [→]-key zur Eingabe der
Schaltrichtung
• In the "RG" column enter the direction
"R" (=branch off) or "G" (= straight) by
the keys [+] or [↓] respectively
• Confirm with the [↵] key
• The programming jumps to Step 1, addi-
tional steps can be entered as described
above (up to Step 9)
• Return to running with the [menu] key
01.03.2007
Point Routes
Prog
0 1 R
13:57 Uhr Seite 91
Calling up the Point Routes
• Press the [mode] key as required until
the TWIN-CENTER is in Memo mode
• Pressing key1 will call up the previously
programmed point route 1
Quick Entry
91