Basic Settings; The Speed Controller; The Keyboard-Mode; The S88-Mode - FLEISCHMANN TWIN-CENTER 6802 Handbuch

6802_10_12_04_Handbuch_GB
15 The TWIN-CONTROL

15.3 Basic Settings

The TWIN-CONTROL has the same properties as
the TWIN-CENTER regarding its basic settings
and the effect of the operation on the TWIN-
CONTROL.
The basic settings of the TWIN-CONTROL can be
altered via an operator lead menu and will then be
continually stored in the memory.
To access the setting menus, the [menu] key and
the [mode] key must be pressed one after the
other.
Menu Structure
The structure of the basic setting menu is com-
parable to that of the TWIN-CENTER. The con-
tent of this menu is however, smaller than the
TWIN-CENTER, because no inputs are necessary
here and all of the connections and programming
can be carried out by the TWIN-CENTER.
The pre-sets are denoted by a *.
The meanings of the basic settings can be found
in the following chapters:
Operation
Language
Display
Special Option
Software Version

15.4 The Speed Controller

The functions of the TWIN-CONTROL are already
well known through the TWIN-CENTER.
The TWIN-CONTROL has two inbuilt controllers
which are completely independent from each
other. They can be found located on the left and
right hand sides of the operating unit. Loco-
motives can be called up and controlled from eit-
her controller.
Simultaneously digital decoders with different
data formats can be controlled and operated. The
controllers will work even whilst the programming
or whilst the settings are changed.
142
01.03.2007 13:58 Uhr
You can refer to the controller functions in the
following chapters of the TWIN-CENTER:
Operation elements
Loco addresses
Speed controllers
Light and special function
Inertia Settings
Loco/ track precedence
Special emergency stop
Altering data format for
individual loco decoders
Virtual loco addresses
Double-heading
Data compression
Operation of function decoders see chapter 7.13

15.5 The Keyboard-Mode

The functions of the TWIN-CONTROL are already
well known through the TWIN-CENTER. The
information to call up and operate the keyboard
mode can be found in the following chapters of
the manual:
Switching points ans signals
Altering key allocation
see chapter 7.3
Keyboard table-mode
see chapter 6.3.4
see chapter 6.3.5
see supplement A1

15.6 The s88-Mode

see chapter 14.12
The TWIN-CONTROL has the same operation for
s88 mode as does the TWIN-CENTER. For further
information, please refer to chapter 11 of the
manual.
15.7 The Memo-Mode for
For the following functions, which are already well
know from the TWIN-CENTER, can also be car-
ried out by the TWIN-CONTROL.
Switching point routes
Changing point route groups
Seite 142
see chapter 7.1
see chapter 7.2
see chapter 7.3
see chapter 7.4
see chapter 7.5
see chapter 7.6
see chapter 7.7
see chapter 7.8
see chapter 7.9
see chapter 7.10
see chapter 7.12
ADVICE
s88 module can only be connected to the
TWIN-CENTER.
switching point routes
see chapter 8.2
see chapter 8.3
see chapter 8.4
see chapter 9.2
see chapter 9.3