Possible Cause - Walker Bay Genesis 310 FTL Handbuch

TROUBLESHOOTING
PROBLEM
Buoyancy chamber loses air:
Floor not rigid enough (AIR models only):
Boat does not get on plane:
Boat porpoises:
Boat rides bow down:
Water accumulates in hull:

POSSIBLE CAUSE

- Tube valve is loose.
- There is a leak.
- Air pressure is too low.
- Motor is improperly trimmed.
- There is too much load.
- Motor is too small.
- AIR models, floor is under inflated.
- Motor is improperly trimmed.
- Boat is loaded incorrectly.
- Motor is improperly trimmed.
- Boat is loaded incorrectly.
- Drain plug is open.
- Genesis (RIB): Tube seal is incorrectly installed.
POSSIBLE SOLUTION
- Tighten valve (see OPERATION OF VALVES).
- Repair leak (see REPAIRS).
- Adjust air pressure (see INFLATION).
- Adjust motor trim (see MOTOR TRIM).
- Adjust load (see LOADING).
- Change motor size (see MOTOR SELECTION).
- Adjust air pressure (see INFLATION)
.
- Adjust motor trim (see MOTOR TRIM).
- Adjust load (see LOADING).
- Adjust motor trim (see MOTOR TRIM).
- Adjust load (see LOADING).
- Close drain plug (see FEATURES & DECK PLANS).
- Install tube correctly (see Genesis Assembly).
15