Safety Information - Gaggenau ik 300 254 Gebrauchsanleitung

Safety information

Before you use the appliance:
q Please read the operating and
installation instructions carefully!
They contain important information
on how to install, use and maintain
the appliance.
q The manufacturer is not liable if you
fail to comply with the instructions
and warnings in the operating man
ual. Please retain these operating
and installation instructions as they
may be required by a subsequent
appliance user.
Observe safety procedures
when installing and
connecting the appliance
q Make sure that the appliance
cannot topple over
Before the doors are opened the
anti tilt device must be installed
on the appliance (see installation
manual).
q Install and connect the appliance as
described in the installation manual.
The connected loads of the power
supply (voltage, current type and
frequency) must correspond to the
specifications on the rating plate.
The rating plate can be found in the
appliance at the bottom right hand
side in the refrigeration
compartment (Fig. i).
q The electrical safety of the appliance
is not guaranteed unless the
earthing system in the building
electrical system has been correctly
installed.
q Do NOT switch on a damaged
appliance. If in doubt, contact
the supplier.
q Ensure that the refrigeration tubing
is not damaged during transportation
and installation. Leaking refrigerant
may cause eye injuries.
q Do NOT cover or block the ventilation
slots! (If carrying out modification
work, do NOT reduce the size
of the slots).
q Connect the fresh water inlet to
a drinking water tap/connection.
ALWAYS observe the following
pressures:
1. Minimum water supply pressure:
1 bar
2. Maximum water supply pressure:
10 bar
If the water pressure is below 1 bar,
the appliance will NOT function.
If the maximum permitted pressure
exceeds 10 bar, the appliance may
be damaged.
q Ensure that any water filters con
nected upstream of the appliance
are properly maintained.
q Do not operate the appliance until
it has been installed. Otherwise,
the appliance could tilt forwards
when the doors are opened.
q The IK 300 may only be moved
when empty. The sole purpose of the
integrated rollers is to aid installation
of the refrigerator, i.e. they are NOT
suitable for conveying the appliance
over a distance of more than 4 m
(approx.). The appliance may also
be damaged if it is conveyed over
an uneven or excessively soft
surface.
de en
31