What Does This Switch Do - Milnor 48040F7N Betriebshandbuch

Pivot selector switch (
pivot. Set this switch to the left position to facilitate unloading; use the right position to tilt the
front of the machine up for easier loading.
Tilt direction switch—actuates the necessary devices to raise or lower the selected end of the
machine. On dual-pivot machines, this switch works with the pivot selector switch to tilt the
machine. With the door open button pressed, turn the switch up to raise the selected end of the
machine, or down to lower it.
To tilt a dual-pivot machine backward for easier loading, first set the tilt front/rear selector switch
to the right, as shown in
point. Next, hold the tilt direction switch in the up position and press the door open button (
The front of the machine will tilt up and back until the front is fully tilted or you release either of
the two controls. Use similar procedures to lower the front of the machine to the normal position,
or to raise the rear of the machine for unloading.
To tilt a single-pivot machine, hold the tilt direction switch in the desired position and hold the
door open button (
l
Door open/close switch (
To open the door, turn the switch to the right (
Turn the switch to the left (
controls when the door is in the correct position. The hydraulic pump which powers the door
shuts off automatically when the door is fully open or fully closed.
Door open button (
door open button while the machine is operating removes power from the 3-wire circuit,
stopping the machine. When the machine is idle, this button must be pressed to perform any
other loading or unloading function. This requirement helps ensure that you have both hands
safely on the control panel of the machine if the basket might turn under power while the door
is open.
WARNING 2 : Fall, Entangle, and Strike Hazards—Contact with the turning cylinder can
crush your limbs. The cylinder will repel any object you try to stop it with, possibly causing the
object to strike or stab you. The turning cylinder is normally isolated by the locked cylinder door.
• Do not tamper with or disable any safety device or operate the machine with a
malfunctioning safety device. Request authorized service.
Jog direction switch (
loading or unloading the machine. To jog the cylinder clockwise, hold the jog direction switch
to the left ( ) while pressing the door open button.
J
Door hydraulic circuit pressure gauge—on the rear panel of the machine, this gauge displays
the pressure in the hydraulic circuit when the door is opening and closing. During normal
operation, this gauge registers 0 unless the hydraulic door opening or closing. When the door
is moving, this gauge indicates about 900 psi (62 bar) when the hydraulic system is properly
adjusted.

What does this Switch do?

1.1.5.
Other buttons and switches are used to control additional standard and optional machine
functions. These miscellaneous controls are located and described in this section.
Mildata/Local selector switch
Figure 1), allows the machine to communicate with a Mildata network. A Mildata network
connects several machines together and allows them to share wash formulas and other data
with the Mildata computer. When this switch is in the Mildata position (
/ )—determines whether the machine tilts on the forward or rearward
u U
Figure 5. This determines that the machine will tilt on the rear pivot
) until the machine reaches the desired angle.
/ )—controls the automatic door system when the machine is idle.
d D
) and press the door open button to close the door. Release the
d
)—enables other loading controls when the machine is idle. Pressing the
l
/ )—allows you to jog the cylinder slowly in either direction to help in
J j
(Figure 6)—located on the microprocessor control box (see
11
) while pressing the door open button (
D
PELLERIN MILNOR CORPORATION
Chapter 1. Controls
).
l
).
l
) and you enter a
-