Hvad Er Lastknapper; What Are The Loading Controls - Milnor 48040F7N Betriebshandbuch

Kapitel 1. Knapper

Hvad er lastknapper?

1.1.4.
Lastknapperne lader dig åbne og lukke lågen ,
samt skubbe vip og cylinderen; anvendes
primært, når en kipbar maskine læsses og
a flæsses..
Milnor fremstiller maskiner med to forskellige
t yper vippemekanismer:
• Modeller med enkelt drejetap, inklusive
modellinjen E_N og J_N, vipper hydraulisk
fra en enkelt tapaksel nær bagsiden af
maskinen. Disse modeller vipper for at
aflæsse ved at sænke den forreste del af
maskinen til under den normale
driftsposition, og vipper for at læsse ved at
hæve den forreste del af maskinen til over
normal driftsposition.
• Modeller med dobbelt drejetap, inklusive
vippemodeller i linjen F_W, vipper
pneumatisk fra drejeakser nær forsiden og
bagsiden af maskinen. Disse modeller
vipper for at læsse ved at oppuste
luftblærerne under den forreste del af
maskinen og vipper for at aflæsse ved at
oppuste luftblærerne under den bageste del
af maskinen.
Symbolerne på maskinens kontrolpanel varierer,
alt efter om maskinen er en model med enkelt
e ller dobbelt drejetap.
PELLERIN MILNOR CORPORATION
What are the Loading
Controls?
Loading controls allow you to open and close
the door, as well as tilt and jog the cylinder;
used primarily when loading and unloading a
tilting machine.
Milnor manufactures machines with two
different types of tilting mechanisms:
• Single-pivot models, including the E_N
and J_N model lines, tilt hydraulically
from a single pivot axis near the rear of
the machine. These models tilt to unload
by lowering the front of the machine
below the normal operating position, and
tilt to load by raising the front of the
machine above the normal operating
position.
• Dual-pivot models, including tilting
models in the F_W line, tilt
pneumatically from pivot axes near the
front and rear of the machine. These
models tilt to load by inflating air
bladders below the front of the machine,
and tilt to unload by inflating air bladders
below the rear of the machine.
The symbols on the machine control panel
vary according to whether the machine is a
single- or dual-pivot model.
40