Kapitel 3. Signaler og fejl
Kapitel
Signaler og fejl
B ICWCT04 (Published) Book specs- Dates: 20070924 / 20070924 / 20110221 Lang: DAN01 Applic: 68036F5N
3.1.
O peratørindblanding
Når et program starter, kører maskinen normalt
automatisk. Maskinen afgiver signalet, hvis en
operatør skal tage en beslutning eller foretage
noget manuelt. De mest almindelige årsager til,
at du skal tilse maskinen, er fejl eller i visse
tilfælde manuel tilsætning af kemikalier.
F ejl med operatørsignalet
3.1.1.
Operatørsignalet lyder, og signallyset blinker,
hvis en fejl forårsager maskinstop. Disse fejl
deaktiverer normalt det treledede kredsløb, og
inkluderer en udløst vibrationskontakt eller fejl i
omformeren, der kontrollerer motoren.
viser, hvordan en vibrationskontaktfejl
forekommer på displayet.
PELLERIN MILNOR CORPORATION
3
Figur 16
3
Chapter
Signals and
Errors
Operator Intervention
Once a formula starts, the machine usually
runs automatically. The machine will sound
the signal if an operator needs to make a
decision or do something manually. The most
common reasons you'll need to attend to the
machine are errors, and to manually add
chemicals in some cases.
Error with Operator Signal
The operator signal will sound and the
beacon will flash if an error causes the
machine to stop. These errors usually disable
the three-wire circuit, and include a tripped
vibration switch or a malfunction of the
inverter that controls the motor.
shows how a vibration switch error appears
on the display.
62
Figure 16