What Are The Loading Controls - Milnor 48040F7N Betriebshandbuch

Chapter 1. Controls
Start button ( )—starts the selected wash formula. The start button energizes the 3-wire circuit
1
to allow the machine to operate.
Stop button ( )—stops machine operation. Like the emergency stop button, the stop button
0
disables the 3-wire circuit; however, the stop button doesn't require you to manually reset it
after use.
Run/Program keyswitch (
configuration and wash formulas, among other actions. In the normal Run position, formulas
and configuration are protected and formulas can be run.
Air pressure gauge for tilt system—located behind the lower panel on the rear of the machine;
monitors the air pressure used to tilt the machine.

What are the Loading Controls?

1.1.4.
Loading controls allow you to open and close the door, as well as tilt and jog the cylinder; used
primarily when loading and unloading a tilting machine.
Milnor manufactures machines with two different types of tilting mechanisms:
• Single-pivot models, including the E_N and J_N model lines, tilt hydraulically from a single
pivot axis near the rear of the machine. These models tilt to unload by lowering the front of
the machine below the normal operating position, and tilt to load by raising the front of the
machine above the normal operating position.
• Dual-pivot models, including tilting models in the F_W line, tilt pneumatically from pivot
axes near the front and rear of the machine. These models tilt to load by inflating air bladders
below the front of the machine, and tilt to unload by inflating air bladders below the rear of
the machine.
The symbols on the machine control panel vary according to whether the machine is a single- or
dual-pivot model.
Figure 5: Typical Tilt Control Panels
.
PELLERIN MILNOR CORPORATION
/ )—in the Program position, allows changes to machine
R P
Single-Pivot Model
Dual-Pivot Model
10
Legend
A. Jog direction switch
B. Tilt direction switch
C. Door open/close switch
D. Pivot selector switch