MOTO GUZZI 2003 V11 series Werkstatt-Handbuch Seite 105

A
B
C
D
E
F
G
H
I
L
M
N
O
P
Q
R
38
R Ö 1
ST
EMOVAL WITH HLINS SERIES FORK
• Place a support under the motorbike so you can lift
the front wheel from the ground;
• Remove the calipers as described in Marzocchi fork
removal procedure;
• Loosen the 2 screws fastening the spindle to the fork
right struts;
• Remove the shaft protective cap (right side);
• Unscrew the spindle and remove the wheel.
For information on overhauling, see chapter 3 in section
F.
R Ö 1
ST
EASSEMBLY WITH HLINS
After having carried out all the necessary tests on the
wheel, reassemble in the following way:
• Insert the complete wheel between the fork struts;
• Lubricate the wheel spindle shaft and threading with
recommended grease;
• Grease the threading on the LH strut;
• Screw down the wheel spindle;
• Tighten the 2 screws between shaft and fork right leg
to the specified torque.
• Fit protective cap onto shaft (right side);
• Refit the brake calipers by tightening the fastening
screws to the prescribed torque;
• Check that the disks move freely inside the calipers
and then repeatedly activate the brake lever to restore
the normal position of the caliper pistons.
V11 S M 2003 - L
PORT Y
R C - C
OSSO ORSA AFE
:
:
SERIES FORK
M M 2003
E ANS Y
S - B
PORT ALLABIO VARIANTS