Interface Module - MOTO GUZZI 2003 V11 series Werkstatt-Handbuch

A
B
C
D
E
F
G
H
I
L
M
N
O
P
G
Q
R
98
1 2
A B
C D E F
H I J
K L M N
O P
I
NTERFACE MODULE
This module is used to physically interface the
AXONE2000 with the cables, the sensors and the probes
of the various available kits.
Three different types of interface modules are available.
• Self-test OBD-II
• Measurements
• Modem (for on-line upgrading via the Internet)
Each module is to be used with a specific group of
programs.
The module is clipped into the dedicated housing
in the base of the AXONE200.
The OBD module can be replaced when AXONE2000 is
working, but is recommended to replace the module when
the AXONE2000 is off.
R / U
EAD WRITE NIT
The read/write unit (1) includes a memory card (2),
containing various diagnostic programs.
N.B
Always insert the memory card before switching
the AXONE2000 on. The screen displays an
image prompting you to insert the memory card
if it is missing.
Insert the memory card when the instrument is
off!
Connessioni ingresso/uscita
a. Ground
b. Power supply IN +12 V
c. DSR (COM2)
d. (*)
e. Power supply OUT +5
f. (*)
g. (*)
h. (*)
i. (*)
j. (*)
k. RX (COM2)
l. TX (COM2)
m. (*)
n. (*)
o. (*)
p. (*)
The pins marked with (*) have different uses according
to the interface fitted in the base of the AXONE2000
instrument.
V11 S M 2003 - L
PORT Y
R C - C
OSSO ORSA AFE
(OBD module)
(ACQ module)
M M 2003
E ANS Y
S - B
PORT ALLABIO VARIANTS