MOTO GUZZI 2003 V11 series Werkstatt-Handbuch Seite 191

A
B
C
D
E
B
F
H
I
L
B
M
A
N
O
P
Q
R
124
C
C
D
A
D
36 GEARBOX
Contrary to the previous model, the gearbox is equipped
with a special adjusting eccentric "A" used to adjust gear
selector hook "B" position. Gear selection will thus be
improved and more accurate.
Disassembly, overhaul and reassembly operations are
kept unchanged, but for the following procedure.
36.1 P -
RE SELECTOR COVER
Reassembly and fitting:
· Install pre-selector;
· Fit neutral switch;
· Insert left wheel into the special shaft and move it to
the neutral position;
· Check that hook can easily engage;
· Proceed to wheel correct positioning by meshing the
tooth and the slot marked with a dot. Fit wheel onto
shaft;
· Fit snap rings inside their seats on shafts;
· To check wheels correct operation, adjust hook
position on right wheel;
· Position hook "B" upwards and then turn eccentric
"A" counter-clockwise with a screwdriver to move it
towards hook "B';
· Check that the area between eccentric "A" and hook
"B" – marked on the drawing – is free;
· Position the complete cover on the gearbox and apply
sealant;
· Tighten retaining screws to the torque specified in the
table of sub-section 4 of section B;
CAUTION
When fitting the pre-selector cover, make sure
that gear is in neutral.
V11 S M 2003 - L
PORT Y
R C - C
OSSO ORSA AFE
M M 2003
E ANS Y
S - B
PORT ALLABIO VARIANTS