MOTO GUZZI 2003 V11 series Werkstatt-Handbuch Seite 121

A
B
A
C
D
E
F
G
H
I
L
M
N
O
P
Q
R
54
20 FRONT FORK OIL CHANGE "ÖHLINS"
IMPORTANT
B
The same internal components are used in both
stanchions-sliders. The procedures described
below apply to both fork stanchions-sliders
· Remove the stanchion-slider assembly, see 17
(REMOVING THE STANCHION TUBES AND
SLIDERS)
· Clean stanchion and slider thoroughly.
IMPORTANT
Make sure to have the special tools A (no.
AP8140424) and B (no. AP8140149) and a
1
container with a capacity greater than 550 cu.
cm. ready at hand before proceeding.
· Place the stanchion-and-slider assembly in a vice.
2
Position the two shells of the special tool "B" to the
vice jaws to protect the stanchion-and-slider
assembly.
· Turn the top adjuster screw "1" fully anti-clockwise to
reduce rebound damping force.
· Turn the spring preload top nut "2" fully anti-clock-
wise.
· Release the top cap "3" from the slider using the spe-
cial tool "A".
· Push down the spacer tube "4" and fit a spanner to
the nut to lock out damping cylinder rotation.
3
· Release and remove the top cap "3" while holding
the damping cylinder with the spanner.
· Remove the spacer tube "4".
3
4
V V11 S M 2003 - L
ARIANTI PORT Y
R C - C S
OSSO ORSA AFE PORT
M M 2003
E ANS Y
- B
ALLABIO