Symbols; Instructions; Guarantee; Maintenance And Metrological Verification - Metrix Multimetrix X 4010 Bedienungsanleitung

1.1.3

Symbols

Refer to the user's manual.
Incorrect use may result in damage
to the device or its components.
Risk of electric shock
1.1.4

Instructions

- Any repair, maintenance or adjustment of the oscilloscope when it is powered may only be
done by qualified personnel, after reading the instructions in this manual.
- A "qualified person" is a person who is familiar with the installation, construction and use and
the dangers present. He is authorized to switch the installation and equipment on and off in
accordance with the safety rules.
- Before opening the apparatus, always disconnect it from the mains power supply and
measurement circuits, and make sure that you are not charged with static electricity which
could damage internal components.
- Take care not to obstruct ventilation holes when using the apparatus.
Some internal capacitors may retain a dangerous potential, even after the
apparatus has been switched off.
The replacement fuse must be identical to the original fuse (0,5 A, 250 V, T).
1.2.

Guarantee

This oscilloscope is guaranteed against any material defect or manufacturing vice in accordance with
the general conditions of sale.
During the guarantee period (1 year), the apparatus may only be repaired by the manufac-turer, and
the manufacturer will be free to decide to repair or replace all or part of the apparatus. The guarantee
conditions state that the manufacturer will pay for return transport.
The guarantee is not applicable in the following cases:
1. any improper use of the equipment or if it is used in association with incompatible equipment;
2. modification of the equipment without explicit authorization by the manufacturer's technical
departments;
3. work done by a person not approved by the manufacturer;
4. adaptation to a specific application not included in the definition of the equipment or by the operating
instructions;
5. a shock, drop or flooding.
1.3.

Maintenance and metrological verification

Return your instrument to your distributor for any work to be done within or outside the guarantee.
1.4.

Servicing

Clean the instrument with a wet cloth and soap. Never use abrasive products or solvents.
19
Earth
Ground