Before You Start; Getting Started; Assembling And Setting Up The Multi-Cooker - Silvercrest SMKE 1500 A1 Bedienungsanleitung Und Sicherheitshinweise

6. Before you start

Unpack the appliance. First check whether all the parts are complete and undamaged. If any items are
missing or damaged, please phone our hotline (see "Warranty information" on page 89). Keep the
packaging material away from children and dispose of appropriately.

7. Getting started

The multi-cooker should be cleaned before first use.
Minor smoke development can occur when the device is heated first.
1. Clean the multi-cooker and all its accessories. For more on this, please refer to the
"Maintenance/cleaning" section on page 86. Then ensure that all parts are completely dry.
2. Place the heater unit (8) on an even, non-slip and dry surface. Do not connect the power cable (6)
plug to the mains socket yet!
3. Place the cooking bowl (5) into the heater unit (8). To do this, align the cooking bowl (5) so that the
contacts on the bottom can be pushed into the socket on the heater unit (8). Carefully push the
cooking bowl (5) down so it is seated firmly on the heater unit (8).
4. Fill the cooking bowl (5) with water to the MAX mark.
5. Place the glass lid (1) on the cooking bowl (5).
6. Make sure that the temperature controller (11) is in the "0" position.
7. Connect the power cable (6) plug to a live mains socket. The green "Heating off" indicator (10) then
comes on.
8. Turn the control dial (11) to the "3" position. The device then begins to heat up. The green "Heating
off" indicator (10) goes out and the red heating indicator (9) comes on.
9. Allow the water to boil for 10 minutes. You can then move the temperature controller (11) back to
the '0' position to switch the device off.
10. Disconnect the power cable (6) plug from the mains socket.
11. Once the device has cooled down completely, clean it again. It is then ready to use.

7.1 Assembling and setting up the multi-cooker

Warning!

Only use the device in dry, enclosed spaces. Never use it outdoors.

Place the multi-cooker on an even, stable and heat-resistant surface only. If the multi-
cooker is not placed on an even surface, the movement of the boiling contents could
make it tip over, possibly causing damage to property and burns.
SilverCrest SMKE 1500 A1
English - 65