Replacing The Display Pc Board - Recerbo - Fronius Symo 3.0-3-S Serviceanleitung

Replacing the Removing the Recerbo:
Display PC board
- Recerbo
Follow the safety rules (see the beginning of the "Safety" section)
Installing the Recerbo:
1
NOTE!
If the snap-off PC board is forgotten or not inserted correctly, the inverter will dis-
play a status code (482)
WARNING!
(1)
(2) (2)
(4)
Remove the snap-off PC board from the new Recerbo
(4)
Remove the inverter from the wall bra-
1
cket, open, and remove the Datama-
nager card (see "Opening and Closing
the Device" and "Replacing the Data-
manager Card" sections)
Disconnect all connections to the
2
Recerbo
Remove the external fan cable from
3
the cable guide (1)
Push the locks (2) on the Recerbo hol-
4
der up
Remove the Recerbo module
5
NOTE!
In the next two steps, ensure that no
(3)
components are damaged
Remove the holder (3) from the
6
Recerbo
Remove the snap-off PC board (4)
7
from the faulty Recerbo
Insert the snap-off PC board (4) on the
2
inner side of the new Recerbo after
(3)
dismantling it
Mount the Recerbo holder (3) on the
3
new Recerbo
- thread the wire up
- press down
NOTE!
All guide pins and bolts must be snap-
ped into place
97