GM-Racing GENIUS 90 Bedienungsanleitung Seite 41

#0 IDA system: setting the values using a PC (with USB and Windows 2000, XP, Vista):
A PC and software can be used with the IDA system to read out and / or program the speed
controller data. The USB-driver and controller programming software (AS Genius Tool) can be
downloaded from the Download area of www.gm-racing.de or www.graupner.de.
Install first the USB-driver and second the PC-software.
The desired set-up values can then be selected using the mouse.
0 IDA system: sending and receiving DATA using a PC and USB port:
(no separate power source required!)
Disconnect the Genius speed controller from the power supply.
Download the appropriate USB driver for Order No. 7186.6 and install it on your PC.
Connect the USB adaptor, Order No. 7168.6, to a vacant USB port.
Install the AS Genius Tool PC software, start the program, Update the Ports, select the right port
(COM) parameter, click on the port in use, and enable it.
Transferring speed controller data from and to the PC:
1.) If you click with the mouse on "Receive data", the PC software switches to "Waiting for data",
and you can read out the data from the Genius speed controller using the following procedure:
2.) Connect the eight-pin interface plug to the appropriate socket on the controller. After a brief
period the yellow LED lights up, indicating that the IDA program has started. If the yellow LED
does not light up after a few seconds, hold the SET button on the controller pressed in, and
briefly press the RESET button on the USB adaptor until the yellow LED lights up.
3.) After a short period the yellow LED will go out, and the data is sent.
4.) The LED lights up yellow once the controller has sent the data. The Genius controller now
waits for data.
5.) If you now wish to transfer data to the controller from the PC, click on "Send data".
6.) Otherwise, i.e. if you only wish to read out the data from the controller, and do not need to
program it using the PC, simply disconnect the interface plug from the controller.
7.) The red LED lights up once data has been received from the PC. Disconnect the data lead
and the speed controller is ready for use again next time you connect the power source. If the
button function has been activated as the switch and switch on was not selected, then next time
you use the speed controller, you must press the button to ensure that the controller is switched
on.
18