GM-Racing GENIUS 90 Bedienungsanleitung Seite 44

Modus-Programmierung GENIUS:
Programming mode # 0 - 8 with SET-button and transmitter:
If the controller is to work properly then all the throttle functions shoud be set to normal (Futaba "REVERSE"),
and travel to 100%.
The receiver puls width must be longer at full throttle compare to the neutral point. The values of the full
throttle, neutral point and full brake position can be checked and adjusted with the PC-Software.
Important information:
Modes 2-8:
If reserved1 = 0, 4, 8, 12, 128, 132, 136 or 140, the transmitter ways will be learned together with the new mode.
Disable learning the transmitter ways:
If reserved1 = 130, 134, 138, 142, the transmitter ways will not be learned, only the mode will be changed.
The transmitter ways will be read out of the mode values from the EEPROM.
Mode 0:
The programmed throttle way for Mode 0 will be used from the last Mode (>=2) programm settings or can be
programmed with the PC-software. The transmitter ways in this mode can be changed with the PC software.
Mode 1:
The programmed full brake position for Mode 1 is used from the last mode setting or from the EEPROM values, if the
transmitter learning process is disabled.
Programming mode #0-8 (4 + 5 is with reverse function others forward with brakes):
1. Switch on the transmitter and
next connect/switch on the speed
controller to the drive battery.
(The motor must be connected
to the speed controller)
Depending on the
mode 0-8 short beeps
SIGNAL
LED
red
ye
rot
5. The Mode can be choosed with changing the throttle stick position.
Stay at neutral position = Mode 0, go to full throttle = Mode 1, go to full throttle - full brake = Mode 2,
go to full throttle - full brake - full throttle = Mode 3, and so on.
There is about 4s time for every stick position change. The LED will change the colour every change
and you will hear the beeps for the actual mode.
If mode 1 is beeped at the full brake position, you have to reverse the transmitter throttle way.
(If you want to do a factory reset, push now the SET-button again, until you hear 3x short and 1 long beep.)
After the last mode change both LEDs will be off and then you will hear one long beep with red LED on and
the confirmation beeps for the mode again. The speed controller is now ready to use again.
Mode 0
Mode 1
"full throttle"
"neutral=Motor off"
red ye
rot
red ye
rot
red LED off,
yellow LED on
2. Move the throttle
stick to the
"Neutral/Motor STOP"
position
...
"Neutral=Motor STOP"
...
red ye red ye
rot
rot
red LED flashes,
yellow LED on
Mode 2 Mode 3
"full brake"
"full throttle"
red ye
red ye
rot
rot
3. Press the SET-button for about 4s,
until the red LED is on and you hear
a long beep. After the beep the yellow
LED will be on and you can program
the throtlle ways and the modes.
red ye
rot
red LED on,
yellow LED off
Mode x
red LED on,
yellow LED on
"full ..."
red ye
rot
0-8x
red LED flashes,
yellow LED on
4s
delay
red ye
rot
1s
delay
red
ye
rot
red ye
rot
21