Installing The Controller In The Model; Connecting The Controller To The Receiverer - GM-Racing GENIUS 90 Bedienungsanleitung

Installing the controller in the model:

After unpacking the controller think carefully about what position in the model will be ideal. Please keep
in mind that the controller must be optimally cooled, and that both the receiver and the aerial should
have more than 3cm distance to the controller and the thick high-current cables and the battery. After
deciding where to place the controller fix it in place with two strips of double-sided adhesive tape, so
that the cooling surface shows upward for better cooling, or is reduced in surface by no more than 30%.
Connecting the controller to the receiver:
By factory standard, your GM controller is equipped with a Graupner/JR plug which fits into
Graupner/JR as well as Futaba and KO (models 1995 and later) receivers. When using other receivers
please inquire after the proper polarity.
Red =
Black or brown =
White or orange =
Insert the plug of the receiver connector cable into the desired servo socket (socket 2 on car models) of
your receiver.
Switch the transmitter on, with the throttle set to position "Motor Stop", before connecting the drive
battery!
receiver (+)
receiver (-)
pulse cable
5