GM-Racing GENIUS 90 Bedienungsanleitung Seite 39

#16 RESERVED
Attention! If you use uneven values for RESERVED, the warranty will be lost and the temperature
protection will be switched off!
32-39 new brake software will be activated for AUTOBRK
48-57 new brake software will be activated for AUTOBRK and throttle BRAKE
64 only brushed motor configuration #4 without reverse is allowed
128 current limiter for brake off
...
128 + other functions...see PC software or above
recommended values for Touring cars are: 6 and 22!
#17 FREQUENCY
0 = 8 kc
1 = 8 kc, with adjustable current drain limitation
2 = 16 kc
3 = 16 kc, with adjustable current drain limitation
4 = 2 kc
5 = 2 kc, with adjustable current drain limitation
8 = 4 kc
9 = 4 kc, with adjustable current drain limitation
Lower frequencies run the speed controller cooler and gives you a smoother power feeling.
Higher frequencies are more efficient to the motor and gives you more power.
New feature - and so far unattained!
Instead of altering the pulse width we control the current. This helps keep the controller's behaviour
constant over the entire running time, independent of the battery tension, and so enables you to achieve
almost the same elapsed time for all laps until the battery load is finished, and, in particular, keeps the
controller's attitudes constant. By using the throttle curves and the current limitation you can optimally
adjust the controller functions to the model's needs and to the situation, even when the max. motor
power is used at "full throttle".
Factory setting: dependend on the mode factory setting, with adjustable current drain limitation
recommended values for the current limitation: 60-200 A
Programming the supplementary functions which are only programmable using the PC software:
#18 RESERVED1 (0 to 142)
0 = send data #1 to #17 (for programmer #2894.12 or GMVIS-Commander V2005 and later),
program transmitter ways, when changing the mode with the transmitter and SET-Button
2 = Do not program transmitter ways, when changing the mode with the transmitter and SET-Button
4 = long beep after switch on the speed controller disabled
8= short beeps for mode confirmation after switch on the speed controller disabled
128 = send all data,
program transmitter ways, when changing the mode with the transmitter and SET-Button
130 = send all data,
Do not program transmitter ways, when changing the mode with the transmitter and SET-Button
...128+ other functions...see above or at PC-software
#19 SOFT BRAKE (0 TO 200)
The smaller the set value, the softer the braking effect of the controller (see SOFTGAS for values/2).
1 = brake engage time 2 sec.
2 = brake engage time 1 sec
...
50 = brake engage time 40 ms
100 = brake engage time 20 ms
see PC-Software!
16