Adjusting The Controller To The Transmitter Stick Travel, Programming The Main Functions - GM-Racing GENIUS 90 Bedienungsanleitung

Adjusting the controller to the transmitter stick travel, programming the main functions, setting
the supplementary functions back to their default values:
If the controller is to work properly then all the throttle functions shoud be set to normal (Futaba
"REVERSE"), and travel to 100%.
The receiver puls width must be longer at full throttle compare to the neutral point. The values of
the full throttle, neutral point and full brake position can be checked and adjusted with the PC-
Software.
As the controller uses the motor as a loudspeaker for the beep sounds, you can hear the beeps only
when the motor connector is plugged in. If the motor is not connected, the speedo controller will go into
the error mode.
Programming with the USB-adapter #7168.6 is possible without motor and battery.
When Hall sensors are activated the LEDs show the positions of two Hall sensors and don't work as
described later on in this manual. It is therefore recommended to disconnect the Hall sensors before
connecting the power supply cables. Expert programmers, however, may programme the controller also
without the help of the beeps.
The controller has pre-set stick travels. The factory setting is for model mode #1 (forward with brakes),
and is suitable for all models using the LiPo switch-off. This mode allows for all models to be run with all
sorts of batteries, for a start.
to position "motor stop / brake", or else the motor won't start up for safety reasons. If the motor brakes in
the full throttle position but starts up in the brake position then you should programme the stick to
"reverse"!
The correct settings of the transmitter travels will light these LEDs:
the red and the yellow LED when the stick is in position "motor stop / brake"
-
the yellow LED in the "throttle control range"
-
the red LED in the "full throttle range"
-
no LED in the "brake control range"
-
- the red LED in the "slam brakes" position.
8
In order to initially activate the motor the transmitter stick should be set