GM-Racing GENIUS 90 Bedienungsanleitung Seite 35

#1 SWITCH ON/OFF button for the controller, save max. current and max. rpm
FUNCTION CONTROLLER ON / OFF (0,1,2,4,5)
The controller can be programmed to allow for it to be switched on / off, together with the BEC system,
by using the SET button. It can as well be programmed for switch on / off over the transmitter by setting
the stick to "slam brake" for at least 16 secs.
Whenever the controller is being switched on it will give a series of 1-4 beeps, according to the selected
mode, and the red LED will flash, so as to acknowledge the model mode # and the switching on.
Save the max. current and max. rpm: The maximum current and maximum rpm will be stored to the
EEPROM, if you switch off the speed controller with the SET-button or 16s full brake.
To do this, the SWITCH function must be programmed to 1, 2, 4, 5 or 6.
The max. current, rpm, top speed and overtemperature can be displayed on the PC screen after reading
out the speed controller datas with the USB-circuit.
If the displayed rpm is not realistic and much too high, timing errors did occur. Try to prevent timing
erros with changing the following functions (FREQUNECY, SOFTGAS, AMPLIMIT, TIMING or setting
the RPM LIMIT to 8 (125000rpm) or 13 (100000rpm).
0 = Controller is always switched on
1 = Controller can be switched on by shortly pressing down the button, and off after pressing it down
one more time
2 = Controller is on after plugging in the drive battery but can be switched on / off again by shortly
pressing down the button.
4 = Controller is switched off after setting the stick to "slam brake" for 16sec, or by pressing the button.
5 = Controller is switched on using the button, and switched off using the button, or holding the stick for
16 sec in "slam brake" position
6 Controller is switched on by plugging in the drive battery and switched off by pressing the button or by
16 sec "slam brake", and switched on again by pressing the button
Reading 64 + the adjusted value means, that the temperature was higher as the cut-off level.
#2 AUTOBRAKE (automatic brake)
The autobrake function is adjustable from 0-100% and it is already starting to brake when the throttle
stick is set to neutral. It is adjustable regardless of the max and min braking action, and therefore allows
driving through tighter bends.
recommended values 0-20%
#3 BRAKEMAX (max. braking action)
Brakemax is the braking action which is applied shortly before the red LED is lit. This is the range
between neutral position and 95% of the throttle way. This function allows to avoid overbraking /
blocking the wheels
The max. braking action within the controllable range is adjustable from 0-100%
recommended values for car models 70-100%
#4 FULLBRAKE (slam brake)
The desired braking action in the throttle position FULLBRAKE can be adjusted seperately from the
max. braking action. This is a handy feature in off-road driving where a good range of controlled brake
application is desirable but full braking action is required for correcting trajectories where jumps need to
be made. Further on, this function is useful as an "emergency brake".
FULLBRAKE is also adjustable from 0-100%.
recommended values 70-100%
#5 MAXREVERSE (max. reverse speed)
The max. reverse speed is adjustable from 0-100%. It may be used to set a limit to the max. reverse
speed of racing boats or on RC cars.
If MAXREVERSE is set to 0, the undervoltage protection does switch from 4V to 3V in NiMH mode.
If the LiPo-discharge protection is deactivated and the cut-off voltage is set to 250. Otherwise the cut-off
voltage setting is used.
Recommended values for racing boats 20-50%, 50-100% for car models
12