GM-Racing GENIUS 90 Bedienungsanleitung Seite 26

Supplementary programmable functions:
The following supplementary functions are available:
#1 On / Off switch function with controller button, save max. rpm and max. current
#2 Automatic brake
#3 Maximum brake
#4 Full brake
#5 Maximum reverse speed
#6 ABS
#7 Automatic throttle
#8 Soft-start
#9 Timing
#10 Speed limiter
#11 Current limiter
#12 Start-up current limiter
#13 Turbo
#14 Power curve
#15 Minimum brake
#16 Reserved, Set-up for temperatur cut-off, Sensormode, Brake modes, motor type
#17 Frequency
#18 Reserved 1, configuration for data transfer, transmitter mode programming, beeps
#19 Soft brake
#20 Full-throttle point
#21 Zero point
#22 Full brake point
#23 Zero point width
#24 Mode
#25 Program number
#26 Low-voltage power-down
#27 Maximum start-up power (PWM width) without sensor
#28 Maximum start-up current without sensor
Content:
Warnings.............................................................................................................................. 4
Installing the controller in the model..................................................................................... 5
Connecting the controller to the receiverer........................................................................... 5
Connecting a brushless motor to the controller (Motorconfiguration #1).............................. 6
Connecting a brushed motor to the controller (forward/motor stop/brake) #2...................... 7
Connecting a brushed motor (forward/motor stop/brake/reverse) #3................................... 7
Adjusting the controller to the transmitter stick travel, Programming the main functions.... 8-10
Reset the values of the supplementary functions to the factory settings.............................. 8-10
Programming mode #0-8....................................................................................................... 8-10
Activating reverse gear/ forward gear................................................................................... 11
Supplementary functions...................................................................................................... 11-17
IDA-System: Programming the values with the PC............................................................... 18
failure announcement........................................................................................................... 19
Technical specifications....................................................................................................... 19
Accesoires........................................................................................................................... 19
short instruction overview..................................................................................................... 20-21
Service................................................................................................................................. 23
(brushless motors only)
(brushless motors only)
(Cut-off voltage)
3