Supplementary Functions - GM-Racing GENIUS 90 Bedienungsanleitung

Activating reverse gear / changing into reverse gear
Both a fully proportional brake and a fully proportional reverse gear are available in mode #4.
To change into reverse set the stick to position "slam brake" and hold it until the vehicle comes to a stop,
and for another second. Then move the stick to "neutral". Reverse gear is now activated. You can now
drive backwards proportionally by moving the stick in the "brake" direction.
Mode 5: Addtionally to mode 4, the reverse function will be enabled in neutral position, if a brushless
motor without hall sensors doesn't turn any more. AUTOGAS and AUTOBRAKE must be set to 0.
Activating forward gear / changing into forward gear
Of course you can also slow the car down proportionally by moving the stick in the direction full throttle.
To change into forward gear after a run in reverse, set the stick to position "full throttle" to slow the
vehicle down, and hold it until the vehicle comes to a stop. Then move the stick to "neutral". Now
forward gear is again activated. You can now drive forward proportionally by moving the stick towards
the "full throttle" position.
Mode 5: Addtionally to mode 4, the reverse function will be enabled in neutral position, if a brushless
motor without hallsensor doesn't turn any more. AUTOGAS and AUTOBRAKE must be set to 0.
Supplementary programmable functions:
Supplementary functions can be adjusted using the GENIUS-Programmer #2894.12 or with the GMVIS-
Commander with software version V2005 or with a PC with USB and Windows 2000/XP/Vista.
#1 On / Off switch function with controller button, save max. rpm and max. current
#2 Automatic brake
#3 Maximum brake
#4 Full brake
#5 Maximum reverse speed
#6 ABS
#7 Automatic throttle
#8 Soft-start
#9 Timing
#10 Speed limiter
#11 Current limiter
#12 Start-up current limiter
#13 Turbo
#14 Power curve
#15 Minimum brake
#16 Reserved, Set-up for temperatur cut-off, Sensormode, Brake modes, motor type
#17 Frequency
Only programmable with the PC-software:
#18 Reserved 1, configuration for data transfer, transmitter mode programming, beeps
#19 Soft brake
#20 Full-throttle point
#21 Zero point
#22 Full brake point
#23 Zero point width
#24 Mode
#25 Program number
#26 Low-voltage power-down (Cut-off voltage)
#27 Maximum start-up power (PWM width) without sensor
#28 Maximum start-up current without sensor
(brushless motors only)
(brushless motors only)
11