GM-Racing GENIUS 90 Bedienungsanleitung Seite 30

Connecting a conventional brushed motor:
The speed controller does automatically detect the motor configuration (except in motorconfiguration #4.
In Motorconfiguration 4 RESERVED must be programmed to 64!)
depending on the MODE
0-8 short beeps
Signal
LED
red
ye
rot
red LED on,
yellow LED off
(Motorconfiguration #2): Connecting a brushed motor for the functions forward/Motor stop/(brake)
fan: 5 - 6 V
receiver wire
LED yellow
SET-button (ON-/OFF)
LED red
Programming plug and
plug for hall sensors
(Motorconfiguration #3) Connecting a brushed motor for the functions forward/Motor stop/brake/reverse
In this mode, only half the indicated permanent current drain is available.
In addition, only batteries of max. 7.4V may be connected in this mode!
fan: 5 - 6 V
receiver wire
LED yellow
SET-button (ON-/OFF)
LED red
Programming plug and
plug for hall sensors
(Motorconfiguration #4) Connecting a brushed motor for the functions forward/Motor stop/brake/reverse
In this mode, only half the indicated permanent current drain is available.
In addition, only batteries of max. 7.4V may be connected in this mode!
RESERVED must be programmed to 64!
fan: 5 - 6 V
receiver wire
LED yellow
SET-button (ON-/OFF)
LED red
Programming plug and
plug for hall sensors
...
...
red ye red ye
rot
rot
red LED flashes,
yellow LED on
orange
-
yellow
+
blue
orange
-
yellow
+
blue
orange
-
yellow
+
blue
red ye red ye red ye
red ye red ye
rot rot rot rot rot
red LED flashes 6x,
yellow LED on
Motor
M
-
+
red shrink tube marking
black
Motor
M
-
+
red shrink tube marking
black
Motor
M
-
+
red shrink tube marking
red ye
rot
black
drive battery
drive battery
drive battery
7