Completion Of Model Vehicle; A) Taking Off The Car Body; B) Installation Of Steering Servo - Reely RHINO Bedienungsanleitung



8. Completion of Model Vehicle

Before you can use your model you have to install the missing remote control components such as
receiver, steering servo, cruise control and drive battery.

a) Taking off the car body

The car body is secured with two holding brackets (1
and 2) which have to be slid out of the retaining pins
from the side. Afterwards the body (3) can be lifted
off towards the top.

b) Installation of steering servo

In order to achieve a precisely adjusted and exactly
working steering you should definitely use a high-
quality standard servo (1) for the steering.
Before placing the servo lever (2) in a 90° angle to
the servo onto the servo axle, in accordance with the
illustration, make sure, that the steering servo is
exactly in centre position.
Our tip:
To do this, use the remote control system and the steering servo and set the steering trim
on the transmitter in centre position. Doing this you ensure that the servo is running in
centre position and the servo lever is screwed together in the correct position with the
servo.
Illustration 1
Illustration 2
35