Replacing Wheels; Interventions On The Machine - GGP ITALY 102 Gebrauchsanweisung

1
The machine has a connector (1) for recharging, to be con-
nected to the corresponding connector of the special "CB01"
maintenance battery-charger supplied (if included) or available
on request ( 8.5).
IMPORTANT
This connector must only be used for
connection to the CB01 maintenance battery-charger. For its
use:
– follow the instructions given in the relative instruction
booklet,
– follow the instructions given in the battery booklet.

6.3 INTERVENTIONS ON THE MACHINE

6.3.1 Cutting deck alignment
The cutting deck should be properly set to obtain a good cut.
If the cut is uneven, check the tyre pressure.
If this is not sufficient to achieve an even cut, please contact
your Dealer for the adjustment of the alignment of the cutting
deck.
1

6.3.2 Replacing wheels

Stop the machine on a flat surface and put a block under a
load-bearing part of the frame on the side that the wheel is to
be changed.
The wheels are held by a snap ring (1) which can be eased off
with a screwdriver.
NOTE
If you have to replace one or both rear
wheels, make sure that any differences in their external
diameter does not exceed 8-10 mm; on the contrary, to pre-
2 1
EN 31