Interventions On The Machine; Replacing Wheels - GGP ITALY 98SD Gebrauchsanweisung

MAINTENANCE

6.3 INTERVENTIONS ON THE MACHINE

6.3.1 Cutting deck alignment
The cutting deck should be
properly set to obtain a good
cut.
If the cut is uneven, check the
tyre pressure.
If this is not sufficient to
achieve an even cut, please
contact your Dealer for the
adjustment of the alignment
of the cutting deck.

6.3.2 Replacing wheels

Stop the machine on flat ground and put a block
under a load-bearing part of the frame on the side
that the wheel is to be changed.
The wheels are held by a snap ring (1) which can be
eased off with a screwdriver.
NOTE
both rear wheels, make sure that any differences in
their external diameter does not exceed 8-10 mm;
on the contrary, to prevent an uneven cut it will be
necessary to adjust the alignment of the cutting
deck.
IMPORTANT
snap ring (1) and supporting washer (2) back in place.
6.3.3 Replacing and repairing the tyres
The tyres are «Tubeless» and so all punctures must be repaired by a tyre repairer fol-
lowing the procedures required for this kind of tyre.
If you have to replace one or
Before remounting the wheel, apply grease to the axle. Put the
33
EN
2 1