Interventions On The Machine - GGP ITALY F72FL Gebrauchsanweisung

– t he steering pins, using the two grease guns
(1);
– t he progress control lever joint using the
grease gun (2) accessible from the hatch
placed at the bottom of the seat.

6.4 INTERVENTIONS ON THE MACHINE

6.4.1 Aligning the cutting-means
assembly (Fig. 6.5)
The cutting-means assembly should be prop-
erly adjusted to obtain an evenly mown lawn.
If mowing is uneven, check the tyre pressure.
If this is not sufficient to achieve an even cut,
please contact your Dealer to adjust the align-
ment of the cutting-means assembly.
6.4.2 Replacing the wheels (Fig. 6.6)
Stop the machine on flat ground and put a block
under a load-bearing part of the frame on the
side that the wheel is to be changed.
The wheels are held by a snap ring (1) which
can be removed with a screwdriver.
NOTE If you have to replace one or both rear
wheels, make sure that any differences in their
external diameter does not exceed 8-10 mm; on
the contrary, you must adjust the cutting-means
assembly alignment to prevent uneven mowing.
IMPORTANT Before remounting the wheel,
apply grease to the axle. Put the snap ring (1)
and shoulder washer (2) back in place.
6.4.3 Repairing or replacing tyres
All puncture repairs or replacements will have to
be carried out by a tyre repair expert in accord-
ance with the methods for the kind of tyre used.
6.4.4 Replacing a fuse (Fig. 6.7)
The machine is fitted with fuses (1) with different
capacities and functions. Specifically:
– 1 0 A fuse = protects the main and power cir-
cuits of the electronic circuit board. When it
blows, the machine stops and the dashboard
light switches off.
– 2 5 A fuse = protects the battery recharge cir-
cuit. When it blows, the battery gradually runs
down and the machine will have problems
starting.
With Honda engine
– 1 0 A fuse = protects the main and pow-
er circuits of the electronic circuit board.
When it blows, the machine stops and the
dashboard light switches off.
– 2 5 A fuse = protects the battery recharge
circuit. When it blows, the battery gradu-
ally runs out and the machine will have
problems starting.
– T 6.3 A (delayed) fuse (2) = protects the
main and power circuits of the electronic
circuit board. When it blows, the machine
stops and the dashboard light switches off.
The fuse capacity is indicated on the fuse.
IMPORTANT A blown fuse must always be
replaced by one of the same type and ampere
rating, and never with one of another rating.
If you are unable to understand why it has
blown, contact Your Dealer.
6.4.5 Replacing bulb (if fitted) (Fig. 6.8)
The bulb (18W) has a bayonet fitting and is in-
stalled in the bulb holder which can be taken out
by turning it anti-clockwise with pliers.
6.4.6 Removing, replacing and
reassembling of cutting means
WARNING!
tive gloves to handle the cutting means.
WARNING!
bent cutting means; never attempt to repair
them! ALWAYS USE ORIGINAL CUTTING
MEANS!
Only cutting means bearing the code indicated
in the table on page ii must be used on this ma-
chine.
Given product evolution, the above mentioned
cutting means may be replaced in time with oth-
ers having similar interchangeable and operat-
ing safety features.
15
Always wear strong protec-
Always replace damaged or