Bosch BPT-M Touch Installationsanleitung Seite 97

English
NOTICE
Bosch Power Tec GmbH
▶
Procedure
1. Remove the device from its packaging.
Material damage due to incorrect installation
If the device is installed using the wrong screws or
fitted too tightly against the wall, the device may be
damaged.
Observe the tightening torques

 Only use the screws supplied
2. If not already fitted, install the top-hat rail.
3. Fasten the top-hat rail clips (1) to the device with
the screws (2).
Please note the following here:
Tightening torque = 0.09 Nm

4. Fit the device onto the top-hat rail with the top-hat
rail clips (1).
Transportation and installation | 27
(1)
(2)
BPT-M Touch | Installation manual