Bosch BPT-M Touch Installationsanleitung Seite 109

English
Bosch Power Tec GmbH
5.8: Connector plug pin assignment: Alarm messenger
Pin Assignment
(11)
Alarm +
(13)
Alarm –
4. Use a slotted screwdriver to open the contact
spring of the connecting plug.
5. Insert the wire end into the terminal according to
the pin assignment.
6. To fix the end of the wire securely in place, remove
the slotted screwdriver from the terminal.
7. Check that the wire is held firmly in place.
8. Repeat steps 3 to 7 for the ends of all other wires.
9. Route the unconnected wires in such a way that
the wires do not hang loose at the side and
possibly cause short circuits
10.Connect the connector plug with BPT-M Touch.
■
The alarm messenger is connected.
In the event of an alarm, the BPT-M Touch activates
the alarm messenger. The alarm messenger is
deactivated again after 5 minutes.
Electrical installation | 39
(13) (11)
BPT-M Touch | Installation manual