Accessing The Bpt-M Touch Directly From A Pc - Bosch BPT-M Touch Installationsanleitung

English
Bosch Power Tec GmbH
 Option for obtaining an IP address automatically
enabled in the BPT-M Touch
Cat 5 network cable or better present

Maximum length: 100 m
▶
Procedure
1. Plug one end of the network cable into the
Ethernet port of the BPT-M Touch (Overview of
connections below the display, p. 19).
2. Plug the other end of the network cable into the
Ethernet port on the router.
3. Start the router. Please note that the BPT-M Touch
cannot obtain the IP address correctly unless the
BPT-M Touch is switched on after the router.
4. To restart the BPT-M Touch, briefly disconnect the
AC adapter from the power supply and re-connect.
■
BPT-M Touch is ready for data transmission to the
Internet portal.
Data will be transferred during the next dial-in of the
BPT-M Touch. The dial-in times can be set in the
Internet portal.
6.3 Accessing the BPT-M Touch directly
from a PC
You can display the BPT-M Touch using an Internet
browser. The manufacturer supports the latest
versions of the following Internet browsers:
Firefox

Internet Explorer

Safari

Chrome

Telecommunication installation | 49
BPT-M Touch | Installation manual