Connecting The Supply Voltage - Bosch BPT-M Touch Installationsanleitung

English
DANGER
Bosch Power Tec GmbH
If you connect the irradiation and temperature
sensor to the CAN distributor of the
SmartConnect generator junction box, note the
assignment:
Irradiation and temperature
sensor
CAN high
CAN low
Sensor 24 V
CAN GND
Sensor 0 V
Connect the Sensor 24 V and Sensor 0 V lines directly
to the positive terminal or minus terminal of the
previously installed power supply.
■
The power supply and the SmartConnect are installed
and connected.
After cabling is complete, wait at least 5 minutes until
the devices are detected.
5.8

Connecting the supply voltage

Risk of death due to electric shock
If you deviate from the indicated connection order,
this may cause serious damage or electric shock.
Observe the order: first connect the central

inverter, then connect the optional components,
then connect the supply voltage.
Electrical installation | 45
CAN distributor
CAN H
CAN L
–
SHLD
–
BPT-M Touch | Installation manual