Checking The Range Of The Remote Control Transmitter - Reely ROAD Ice Land ARR Bedienungsanleitung

4 P
REPARATION
Carburettor linkage
A visual check of the carburettor outlet is possible after removing or before attaching the
air filter.
- Idle speed position (max. 1 mm open carburettor outlet), if necessary, readjust the
adjusting screw at the idle speed (choke limit stop screw).
The idle speed adjusting screw is the little screw on the opposite side of
the carburettor slide.
The throttle / brake linkages have the following impact:
Full throttle: Carburettor slide fully pulled out, brake has no impact
Idle speed: Carburettor slide fully in, adjusting rings are loose on the brake levers.
Brakes: Throttle linkage presses against spring resistance, brake linkages press forward against the fully
deflected brake lever.
Full throttle
Carburettor
outlet
completely
opened
Function control of the throttle/brake servo
- Move the lever of the remote control (channel 2) towards the back (full throttle position).
bremsen.eps
The slide carburettor must now be completely pulled out, the carburettor outlet opened to its maximum.
The brakes have no impact.
If the slide carburettor does not start up when you actuate the remote control, set the Servo Reverse Switch for
channel 2 to "REV" in order to reverse the direction of rotation of the servo.
If the slide carburettor does not start up fully, correct the servo travel at the trim lever (channel 2) of the remote
control transmitter
- Release the lever of the remote control.
Now the slide carburettor must go back to the idle speed position (carburettor outlet opened to approx. 1 mm).
The brake still has no impact.
- Press the lever of the remote control forward as far as it will go (braking)
The slide carburettor must remain in the idle speed position (carburettor outlet opened to approx. 1 mm).
The servo lever at the carburettor linkage pulls against a spring resistance, the servo lever at the
brake linkage actuates the brake lever.
- Release the lever of the remote control again; now the brakes should be released again.
You can adjust the brake linkage by moving the adjustment rings at the brake steering levers accordingly.
4.6
C
HECKING THE RANGE OF THE REMOTE CONTROL TRANSMITTER
In order not to lose control over you model, you should, before each first start or after a crash, check the function
and the range of the RC system.
For the range test, it is sufficient to test the function of the steering servo.
Support the model at the front axle in a way that allows the wheels to hang freely.
- Pull out the antenna of the transmitter completely and switch the transmitter on then the receiver.
- Stride away from the model, approx. 50 m (engine does not run).
- Place the right lever of the remote control and the corresponding trim lever in neutral position
- Move the steering wheel (channel 1) towards the right.
Now the wheels must drive in towards the right!
- Move the steering wheel towards the left.
Now the wheels must drive in towards the left!
- Release the lever of the remote control,
the wheels must turn back into the straight drive position.
Never drive the model with a remote control that is not functioning properly!
In the best case, "only" the model will suffer damages.
If the remote control does not function perfectly, check the charge state of the transmitter first, and
the rechargeable batteries of the receiver, then make sure that no other person is operating a vehicle on your frequency.
If the problem still persists, consult the trouble shooting table.
© REELY 06/07
Idle speed
Carburettor
outlet1 mm
Wheels turn
freely still,
no brake impact stil
bremsen.eps
Braking
Carburettor
outlet 1 mm
full
braking impact
bremsen.eps
43