Reely ROAD Ice Land ARR Bedienungsanleitung Seite 48

4 P
REPARATION
S
TARTING THE ENGINE
Insert the glow plug!
Prop up the model for starting so that the wheels hang freely in the air and that the main pinion
on the lower side does not get blocked!
- Open the lid of the tank and fill in the fuel.
- Use a special tank bottle, in order to avoid spilling.
Only use model fuel for R/C cars!
Never use gasoline or model plane fuel!
- Pull the starter cord (a) several times slowly, in order to ingest fuel
in the carburettor
- Keep doing this until no more air bubbles are seen in the fuel hose
(b) and the fuel just barely gets in the carburettor.
NOTE!
Do not pull the starter cord all the way but rather to approximately
3/4 of its length!
Determine the length of the starter cord by pulling slowly without
ignition!
Never pull out the starter cord with force!
- Place a plug connector with fully charged start battery on the glow
plug.
- Pull the starter cord with energy, until the engine starts up, while
you hold the model firmly with one hand.
- When the engines starts to run, let go of the starter cord and
remove the plug connector again.
Leave the plug connector connected to the engine only briefly.
Otherwise, the glow plug could burn out prematurely.
Switch off engine
- Cut off the air supply to the carburettor.
- Block the exhaust pipe with a piece of cloth, or
- Stop the fly wheel of the engine on the lower side of the car body with
a piece of cloth / with gloves.
The fuel supply should not be disconnected as otherwise the engi-
ne could overheat.
NOTE! If, after several unsuccessful start activities, the starter cord
can only be actuated with excessive
use of power, too much fuel got into the combustion chamber and
the crankcase. The engine is "flooded". Refrain from further start
trials and remove excess fuel in order to avoid damaging the star-
ter cord and the engine!
For this purpose, proceed as follows:
- Carefully turn in the main nozzle needle clockwise, as far as it will go.
- Unscrew the glow plug and check its glow function
- Place a piece of cloth on the engine and pull the starter cord 5-6 times (3/4 of the length!):
Fuel is pumped out and evaporates.
- Insert the glow plug again and turn the main nozzle needle by three rotations anticlockwise.
- Repeat the start activity
If the engine does not start up, at the latest after 10 or 12 times, proceed as described above or try to
eliminate the problem with the help of the trouble shooting table!
46
b
Operating Manual 4WD GP Monster Truck Chassis Item No. 23 43 60 / 61
a