Reely ROAD Ice Land ARR Bedienungsanleitung Seite 59

9 T
ROUBLE SHOOTING
Engine does not run smoothly,
responds badly
Engine overheats
Engine speed does not decrease
C
HASSIS
Model pulls to one side
Model can be controlled but only
with difficulty
Brake has no impact
Clutch does not engage
Clutch does not unlink
Model does not function
Damping not soft and accessible
Shock absorbers lose oil
Model rolls over towards the back
during acceleration
© REELY 06/07
Incorrect or defective glow plug
Wrong or old fuel
Dirty air filter
Mix too rich
Idle speed mix too lean
Idle speed mix too rich
Additional air is sucked via fuel line or
engine
Too little pressure from exhaust line
Mix too lean
Car body too compact
Wrong fuel
Throttle stop screw is misaligned.
Engine sucks additional air
One or several joint rings on the carburettor
are defective
Steering trim is misaligned
Alignment right and left is different
Wheel damaged on one side or bearings
defective
Servo links not properly adjusted
Receiving power of the antenna is too small
Batteries of transmitter and/or receiver empty
Brake linkage misaligned
Clutch shoes worn out or defective
Clutch bell worn out or defective
Fly wheel is loose
Spring for clutch shoes worn out or defective
Main pinion defective
Damaged pinions in the differential
Centrifugal clutch set too loose
One or several dampers are jammed
Piston rod bent
A damping component is defective
Sealings worn out
Centrifugal clutch set too taut
Insert the necessary glow plug
Fill the correct fuel
Wash the latter then use air filter oil
Adjust the main nozzle needle to a leaner mix
Readjust the idle speed mix adjusting screw
to factory setting
Setzen Sie die Leerlauf-Gemischregulierschraube
auf die werkseitige Einstellung zurück
Check/replace fuel hoses and/
or tighten all engine screws
Check exhaust line and, if necessary, replace
Adjust the main nozzle needle to a richer mix
Ensure sufficient air supply and dissipation
to the engine by cutting the car body correspon-
dingly.
Use RC car fuel only
Reset the throttle stop screw to factory setting
Check and tighten all engine screws
Replace the defective joint rings
Correct the neutral position on the remote con-
trol
Reset the alignment on both sides onto 0°
Remove the wheel, clean the bearings and, if
necessary, replace
Place servos in neutral position and readjust
Pull out the antenna of the transmitter complete-
ly. Completely unwind the antenna of the recei-
ver and guide it upwards
Replace batteries or recharge rechargeable
batteries
Correct the adjustment of the brake steering
lever Brake disk worn out Replace brake disk
Replace clutch shoes
Replace clutch bell
Retighten fly wheel.
Replace springs
Replace main pinion
Replace pinions
Reset centrifugal clutch
Clean and/or disassemble dampers
Repair the piston rod
Check and replace the corresponding part
Replace sealings
Loosen the adjusting screw until the model runs
smoothly
57