Commissioning; A) Removing The Car Body; B) Taking The Transmitter Into Operation; C) Inserting The Batteries/Rechargeable Batteries Into The Vehicle - Reely ROAD Carbon Fighter Bedienungsanleitung



9. Commissioning

a) Removing the Car Body

The vehicle body is secured with holding clips which must be pulled out from the retaining pins. The vehicle body can
then be lifted off.

b) Taking the Transmitter into Operation

Open the transmitter's battery compartment and insert batteries or fully charged rechargeable batteries. Observe
correct polarity (plus/+ and minus/-), see label on the battery compartment. Close the battery compartment again.
Switch on the transmitter.
Check the functions at the transmitter. With fully charged batteries/rechargeable batteries, both LEDs on the transmitter
should light up. If the green LED flashes, the batteries/rechargeable batteries are weak and should be replaced soon.

c) Inserting the Batteries/Rechargeable Batteries into the Vehicle

First switch off the speed controller, then put the on/off switch
on the bottom of the vehicle to the "OFF" position (= switched
off).
A retention bracket is attached above each holder on the left
and right of the vehicle; it can be removed easily.
Then insert either 4 batteries or 4 NiMH batteries type AA/
mignon into the two holders at the left and right of the vehicle.
We recommend the use of rechargeable NiMH batteries.
Observe correct polarity (plus/+ and minus/-), see label on the
battery compartment.
Attach the retention bracket to the two holders again to fasten
the batteries/rechargeable batteries.
32