Putting The Rc System Into Operation - Reely ROAD Ice Land ARR Bedienungsanleitung

4 P
REPARATION
4.4
S
TARTING THE
In the ARR version, the receiver is not part of the delivery.
- Remove lid of battery compart-
ment on the lower side of the
transmitter.
- Insert 8 AA (rechargeable) batte-
ries in the compartment,
observe the correct polarity!
- Close the lid again
- Carefully connect both red plugs.
- Place the battery support with the
cables and the plug in the battery
box again.
- Close battery box, without
clamping the cables.
- Insert the lower end of the
antenna guiding tube in the
opening on the receiver box.
- Fasten the antenna wire on the
top at the guidance tube, by
wrapping adhesive tape around it
or by placing a rubber cap.
Do not shorten the antenna!
© REELY 06/07
RC I
NSTALLATION
- Open battery box on the chassis
and
- remove the battery support
of the battery box.
- Open receiver box and carefully
remove the receiver
- Unwind the wire of the antenna
and guide it outwards through the
opening in the cover of the
receiver box.
- Switch the transmitter on.
The green LED lights up.
If the LED does not light up, check
batteries /rechargeable batteries
and replace them, if necessary.
- Place 4 AA batteries (rechargeable
batteries) in the support.
- Observe correct polarity
and tightness.
- Guide the antenna of the receiver
through the antenna guiding tube
- and guide it out at the other end.
- Switch on the receiver with the
switch on the chassis.
The servos must turn in neutral
position.
Always switch ON the transmitter
first then the receiver.
First switch OFF the receiver,
then the transmitter.
41