Checking The Range Of The Remote Control Transmitter - Reely ROAD COUGAR 4.1 Bedienungsanleitung

4 P
REPARATION
- Carefully connect both red plugs.
- Place the battery support with the cables
and the plug in the battery box again.
- Close battery box, without
clamping the cables.
- Insert the lower end of the antenna gui-
ding tube in the opening on the receiver
box.
- Fasten the antenna wire on the top at the
guidance tube, by wrapping adhesive tape
around it or by placing a rubber cap.
Do not shorten the antenna!
- Carefully close the receiver box.
- Make sure that the latch is properly locked
in place.
4.6
C
HECKING THE RANGE OF THE REMOTE CONTROL TRANSMITTER
In order not to lose control over you model, you should, before each first start or after a crash, check the function and the range of the RC
system. For the range test, it is sufficient to test the function of the steering servo.
Support the model at the front axle in a way that allows the wheels to hang freely.
- Pull out the antenna of the transmitter completely and switch the transmitter on then the receiver.
- Stride away from the model, approx. 50 m (engine does not run).
- Place the right lever of the remote control and the corresponding trim lever in neutral position
- Move the steering wheel (channel 1) towards the right.
Now the wheels must drive in towards the right!
- Move the steering wheel towards the left.
Now the wheels must drive in towards the left!
- Release the lever of the remote control,
the wheels must turn back into the straight drive position.
Never drive the model with a remote control that is not functioning properly!
In the best case, "only" the model will suffer damages.
If the remote control does not function perfectly, check the charge state of the transmitter first, and the rechargeable batteries of the receiver, then
make sure that no other person is operating a vehicle on your frequency.
If the problem still persists, consult the trouble shooting table.
46
- Open receiver box and carefully
remove the receiver
- Unwind the wire of the antenna
and guide it outwards through the
opening in the cover of the receiver box.
- Switch the transmitter on.
The blue LED in the leg of the
transmitter should light up.
If the LED does not light up, check
batteries /rechargeable batteries
and replace them, if necessary.
Operating Instructions 4WD Stadium Buggy Chassis COUGAR 4.1 Item No. 23 50 63 / 23 49 68
- Guide the antenna of the receiver
through the antenna guiding tube
- and guide it out at the other end.
- Switch on the receiver with the
switch on the chassis.
The servos must turn in neutral
position.
NOTE!
Switching on:
1. Transmitter, 2. Receiver
Switching off:
1. Receiver, 2. Transmitter