Receiver Battery - Reely ROAD Ice Land ARR Bedienungsanleitung

4wd gp monster truck

Inhaltsverzeichnis

Verfügbare Sprachen

ESCRIPTION OF THE MODEL

Damper plate

The upper end of the shock absorber of an axle right and left is screwed to the damper plate at the front or at the rear.

The shock absorbers are thus somehow interconnected via the damper plate.

Differential

Differential gear. Equalizes the different revolution speeds, e.g. between the wheel on the inside of a bend and the outside of

a bend.

Fuel tank

The fuel tank with snap closing contains 125 ccm and is equipped with an integrated fuel filter. The tank is connected, via a

hose, at the connection nipple in the lid, with the resonance sound absorber. During operation, the exhaust gas effects an

overpressure in the tank, which improves the fuel supply to the carburettor.

Inclination

Inclination of the wheels as viewed from the front:

Main nozzle needle

Regulates the fuel supply to the carburettor

Operating Sequence of the control:

Driver

Transmitter

RC model

"Radio controlled", to be more precise: "Remote Controlled" Model

Receiver

Receives and "translates" the control signals of the remote control transmitter (direction and intensity) for the servo and the

cruise control. The transmitter crystal which is tuned to the receiver crystal ensures the perfect communication between

transmitter and receiver. Transmitter and receiver crystals are thus tuned to one another, so that signals of parallel transmit-

ters cannot disturb this receiver (this model).

Resonance exhaust silencer

The resonance exhaust silencer serves, on the one side, to absorb sounds, on the other side, to display the optimal output

of the engine.

Servo lever (servo arm)

Lever, disk or cross with 4 control levers which transmit the rotational movement of the servo

motor via steering levers.

Servo

Servo motor whose shaft turns in a limited angle in both directions and carries out mechanically a control function via a lever.

Servo reverse switch

(at the remote control transmitter) switches the rotational direction / driving direction of the servo

Servo saver

Cushioned additional link between steering servo and steering link. Sudden, hard shocks on the wheels are dampened by

this link and are not transmitted directly in the servo.

Shock absorbers

The shock absorbers consist of four coil springs in whose center respectively one cylinder with one piston and one piston rod

is located. The springs absorb the travel of the axel halves when traveling on uneven roads. Thus, bounding and rebounding

is limited via the pistons located in the center of the coil springs.

The shock absorbers are fastened between the damper plates at the front and the back and the lower transverse links

Positive inclination

Steering servo

Receiver

Throttle/Brake servo