Trouble Shooting - Reely ROAD Ice Land ARR Bedienungsanleitung

9 T
ROUBLE SHOOTING
RC-S
YSTEM
RC-System does not function
Range of transmitter too small
Servos do not respond correctly
RC-System functions incorrectly,
while the engine is running
E
NGINE OR FUEL SYSTEM
The engine does not start
Engine does not get fuel
Engine starts, but stops again
56
Batteries/rechargeable batteries of transmit-
ter and/or receiver
are empty
Batteries/rechargeable batteries are inserted
incorrectly
Plug of batteries/rechargeable batteries of
receiver is loose
Batteries/rechargeable batteries of transmit-
ter and/or receiver are weak
Receiving power of the antenna is too low
The antenna of the transmitter is not pulled
out
The antenna of the receiver is not pulled out
on its full length
The antenna of the receiver is cut
Batteries/rechargeable batteries of transmit-
ter and/or receiver are weak
Toothed wheels in servo links do not engage
or are defective
Adjusting rings on the servo motor are loose
Servo Reverse Switch was
set on „REV" accidentally
Crystal of receiver is loose
Plug of batteries/rechargeable batteries of
receiver is loose
Receiver damaged, e.g. after a crash
Defective glow plug or empty start battery
Start battery defective
Fuel tank is empty or carburettor is not
filled
Carburettor not correctly set
Fuel is old or dirty
Combustion room full with fuel (flooded)
additional air is sucked via fuel line or
engine
Servo links not properly adjusted
Fuel line, air filter or exhaust
blocked
Main nozzle needle fully turned in
Idle speed mix too lean
Fuel hoses bent
Fuel tank defective
Fuel tank is empty
Fuel line, air filter or exhaust blocked
Carburettor not correctly set
Engine overheats
Operating Manual 4WD GP Monster Truck Chassis Item No. 23 43 60 / 61
Replace the batteries/rechargeable batteries of
transmitter and/or
receiver
Check the polarity of the batteries/rechargeable
batteries
Firmly insert the plug again
Replace the batteries/rechargeable batteries of
transmitter and/or receiver
Pull out the antenna of the transmitter completely
Completely unwind the antenna of the receiver
and guide it upwards
Pull out the antenna completely
Pull out the wire of the antenna completely.
Repair the receiver
Replace the batteries/rechargeable batteries of
transmitter and/or receiver
Repair the servo
Readjust the adjusting rings; use
factory settings
Switch the Servo Reverse onto „NORM"
Reinsert receiver crystal
Firmly insert the plug again
Repair the receiver
Replace glow plug, Charge start battery
Replace start battery
Fill fuel tank and pump fuel in carburettor by pul-
ling the recoil starter cord several times
Reset idle speed and main nozzle needle
Replace fuel and check fuel filter
Unscrew glow plug and proceed
as described in the corresponding chapter
Check/replace fuel hoses and/or tighten all engine
screws
Place servo in neutral position and readjust
Clean blocked parts, if necessary, replace
Readjust the main nozzle needle according to
factory setting
Readjust the idle speed mix adjusting screw
to factory setting
Check and straighten fuel hoses
Replace fuel tank
Fill fuel tank
Clean blocked parts, if necessary, replace
Reset idle speed and main nozzle needle
Check the temperature. Above 150°, the fuel mix
must be enriched. Check if the wheels can move
freely.