Conrad WS-3650 Bedienungsanleitung Seite 60

The barometric pressure values which you get on the radio or Internet are always announced after converting to sea
level.
As long as you know the current correct air pressure at the mounting site of the weather station, you can correct the
weather station display using the "UP" and "DOWN" buttons. Press "NEXT" to move to the next setting.
* TENDENCY
*NEXT* *EXIT*
Pressing the "TENDENCY" button takes you to the menu for setting the sensitivity for changing the display of weather
forecast symbols when the air pressure changes.
3 hPa * UP *
*NEXT* *DOWN*
You can select a value from 2 to 4 hPa, the preset value is 3 hPa (hPa = Hectopascal). Press "NEXT" to move to the
next setting.
*STORM WARNING *
*NEXT* *EXIT*
Pressing the "STORM WARNING" button takes you to the menu for setting the sensitivity for the display of storm
warning symbols when the air pressure changes. The storm warning is shown when the air pressure changes by the
preset value or more within 6 hours.
5 hPa * UP *
*NEXT* *DOWN*
You can select a value from 3 to 9 hPa, the preset value is 5 hPa (hPa = Hectopascal). Press "NEXT" to move to the
next setting.
WARNING OFF*ON *
*NEXT* *OFF*
This is where you switch the storm warning ("ON") or ("OFF"). Press "NEXT" to move to the next setting.
* RELEARN TX
*NEXT* *EXIT*
Press "RELEARN TX" to start a search for the exterior sensors, e.g. when a battery is changed in a n exterior sensor
or when it is not recognised for any other reason. A further confirm check appears:
* CONFIRM
*EXIT*
When "CONFIRM" is pressed, and then the menu is exited, a search for exterior sensors begins, the sensor symbol
" " blinks on the right next to the exterior air humidity measurement (only once you exit the menu!).
Then the last function in the display appears.
60
*
*
*