Troubleshooting - Scheppach PL55Li Originalbetriebsanleitung

Trouble shooting
Problem Possible Cause
The motor does not Battery not inserted
run.
Battery not charged
Battery/device defective
Motor overheats easily Overload of the motor; inadequate cooling
of the motor
Decrease in cutting The saw blade is too small (sharpened too
power when sawing often)
The saw cut is rough The saw blade is dull; the tooth shape is not
or wavy suited to the thickness of the material
The work piece rips or The cutting pressure is excessive or the
splinters saw blade is not suited to the application
24 І GB
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Help
Battery not inserted
Charge battery
Have battery/device checked/repaired by a spe-
cialist workshop.
Prevent overloading the motor when cutting; re-
move dust from the motor to ensure an optimum
cooling of the motor
Re­adjust the end stop of the saw unit
Re­sharpen the saw blade or use an appropriate
saw blade
Use the correct saw blade