Menü Pufferspeicher; Menü Pufferspeicher - Parameterübersicht; Menü Pufferspeicher / Par. 1 - Minimaltemperatur Pufferspeicher - ATMOS SDC12-31ACD01 Handbuch

SDC12-31 ACD01
5.3.11.10 SOURCES Menu / par. 9 – Comfortable EHP operation
Function
This parameter defines whether EHP (electric heating coil of the accumulation tank) should be a full source or only operate
in the antifreeze mode.
Setting range
NOTE
5.3.11.11 SOURCES Menu / par. 10 – Summer heating of DHW with EHP
Function
This parameter defines activation of EHP for summer heating of DHW from the accumulation tank. This function is generally
use in an application with a heater inserted in the accumulation tank.
Setting range
NOTE
5.3.11.12 SOURCES Menu / par. 11 – Delayed switch-on of EHP
Function Activation of EHP can be delayed by the set value for possible ignition of the boiler
Setting range 0...250min
NOTE
5.3.11.13 SOURCES Menu – Naming of SRC-1
For better identification of the source you can select your own name for the SRC-1 source in the length of 5 characters (e.g. )
NOTE Boiler type 5 or 6 must be selected
5.3.11.14 SOURCES Menu – Naming of SRC-2
For better identification of the source you can select your own name for the SRC-2 source in the length of 5 characters (e.g. )
NOTE Boiler type 5 or 6 must be selected
103-DE
OFF – If EHP is activated, values for antifreeze room temperature are calculated
regardless of the control mode. If the boiler is on, EHP is disconnected and the room
temperature is maintained on the basis of the selected control mode.
ON – EHP is a full source covering all demands.
Only if EHP is selected
OFF – EHP operation in the winter period only (the outdoor temperature is lower than
the SUMMER par. or SUMMER control mode)
ON – Operation of EHP in the summer season as well
Only if EHP is selected
Only if EHP is selected
www.atmos.cz
103
ATMOS ACD01 – SERVICE MANUAL EN
TUV
.