Siemens SINUMERIK 840Di sl Inbetriebnahmehandbuch Seite 478

Inbetriebnahme HMI-Advanced (IM4)
2 Funktionen und Parameter einstellen
; path and file names of the alarm text lists
; The filename fragments must not exceed 6 chars, because it is extended
; automatically by the message module according to the selected language.
; The alarm texts in the files specified under UserMMC, UserNCK ...
; overload the corresponding texts of the files defined in MMC, NCK ...
; Therefore the user should modify files according to the needs of his
; system exclusively in UserMMC, UserNCK ...
; Creating alarm text with any DOS-editor may cause Problems with special
; characters like ä, ö or ü. To nevertheless import DOS generated files,
; add a blank and the string "DOS" after the name of the text file.
; Example: UserPLC=F:\dh\mb.dir\myplc_ DOS
; If you add or remove the parameter DOS, you have to touch (new date
; of file) the corresponding file (*.com) otherwise the change is not accepted.
[TextFiles]
MMC=F:\MMC_52\dh\mb.dir\alm_
NCK=F:\MMC_52\dh\mb.dir\aln_
PLC=F:\MMC_52\dh\mb.dir\alp_
ZYK=F:\MMC_52\dh\mb.dir\alz_
CZYK=F:\MMC_52\dh\mb.dir\alc_
STANDARD_CYCLES=F:\MMC_52\dh\mb.dir\alsc_
SHOPMILL_MANUALTURN_CYCLES=
MEASURE_CYCLES=F:\MMC_52\dh\mb.dir\almc_
PLC_PMC=
USER_CYCLES=
UserMMC=
UserNCK=
UserPLC=
UserZYK=
UserCZYK=
UserSTANDARD_CYCLES=
UserSHOPMILL_MANUALTURN_CYCLES=
UserMEASURE_CYCLES=
UserUSER_CYCLES=
UserPLC_PMC=
; NCU-specific texts in M:N environments
; the entry names are build by concatenating the string "PLC" or "NCU" with
; the name of a NCU taken from netnames.ini file.
; Entry names are case sensitive!
; the entry values follow the same rules as in the Textfiles section of this file
; the commented examples below correspond to the netnames.bsp file delivered
[net TextFiles]
;PLCRechteNCU = f:\dh\mb.dir\rechts
;NCURechteNCU = f:\dh\mb.dir\rechts
;PLCMittlereNCU = f:\dh\mb.dir\mitte
;NCUMittlereNCU = f:\dh\mb.dir\mitte
;PLCLinkeNCU = f:\dh\mb.dir\links
;NCULinkeNCU = f:\dh\mb.dir\links
IM4/2-96
(nur bei SINUMERIK powerline)
SINUMERIK 840D sl/840Di sl/840D/810D IBN HMI (IAM) - Ausgabe 01/2006
© Siemens AG 2006 All Rights Reserved
01/2006