Mbdde.ini - Siemens SINUMERIK 840Di sl Inbetriebnahmehandbuch

01/2006
[SetZero]
; Display_Sign_Switch switch the sign of the toollength in the scratch picture
; Display_Sign_Switch=0
; Display_Sign_Switch=1
Display_Sign_Switch=1

2.5.16 MBDDE.INI

[Alarme]
ORDER=LAST
RotationCycle=0
Alarm_S=1
Protocol_Alarm_SQ=1
Alarm_S_FWA_Inactive=1
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl/840Di sl/840D/810D IBN HMI (IAM) - Ausgabe 01/2006
; determines the order in which the alarms are inserted in the alarm list
; possible values:
; FIRST: makes newer alarms stand on top of the list
; LAST: inserts the newest alarm at the bottom
; the alarm/message line is able to scroll the occurred alarms
; possible values:
; 0 or negative value: no scrolling
; 500 - 32767: interval in ms
; determines if the alarm server should connect to ALARM_S/SQ or not
; possible values:
; 0 Alarm_S/SQ not handled
; 1 Alarm_S/SQ handled (default)
; if Alarm_S/SQ handling is enabled this key determines if Quits should
; be entered into the alarm-protocol
; possible values:
; 0 Alarm_SQ quits are not entered into the alarm protocol
;(backcompatible)
; 1 Alarm_SQ quits are entered into the alarm protocol (default)
; If Alarm_S/SQ handling is enabled this key determines if the
; workaround regarding an error in the firmware of the PLC is
; active or not. This workaround corrects the listing of
; Alarm_S/SQ in the diagnosis but causes multiple entries in
; the protocol listing of one alarm event (NEW, NULL, QUIT).
; Using a newer PLC firmware (PLC Besy Stand: S7 PLC_315 2DP
; 2AF03 12.30.03 or higher only neccessary at NCU57x.1) this
; workaround can be set inactive to correct protocol writing.
;
; Attention: Setting the workaround inactive while using an PLC
; firmware elder than 12.30.03 leads to unpredictable results!
;
; possible values:
; 0 Workaround active
; 1 Workaround inactive (default)
Inbetriebnahme HMI-Advanced (IM4)
2 Funktionen und Parameter einstellen
mean - toollength
mean + toollength
IM4/2-95