Commissioning Of The Model; A) Commissioning The Remote Control; Inserting And Connecting The Flight Battery - Reely SZD-54 Bedienungsanleitung

10. Commissioning of the Model

The references in the operating instructions refer to the scope of delivery of the RTF version with item no.
1517960. If you purchased the PNP version with item no. 1517327, no charger, no flight battery and no
remote control are enclosed.
However, you can use these operating instructions as a reference for placement and connection of those
components and install your own components there. Observe the safety notes and operating instructions
for the components you use for this under all circumstances.

a) Commissioning the Remote Control

In the operating instructions for the flight model, only the control elements are illustrated in the figures of the remote
control. They therefore serve illustration purposes only. The precise function of the remote control is explained in the
separately enclosed operating instructions (on CD).
b) Inserting and Connecting the Flight Battery
Figure 17 shows the position of the flight battery (1), the plug system (2), the magnet for the cabin holder (3), the
elevator servo (4), the rudder servo (5), the flight controller (6) and the receiver (7).
After removing the canopy, the flight battery is inserted in the fuselage after taking off the canopy. The flight battery
cables must not touch the rudder horns of the elevator or rudder servos here.
Since the position of the flight battery in the RTF version can only be changed slightly, the correct centre of gravity
must be set by adding trimming weights (also see next chapter).
Figure 17
55