Reely SZD-54 Bedienungsanleitung Seite 60

Motor Function:
Attention!
Ensure that no loose parts, such as paper, film or other objects can be sucked into the rotor during this
motor test. Also make sure that the model is held securely during this test run and that no clothing and body
parts are within the rotation range or danger area of the rotor.
• Push the control lever for the motor function to the bottom position.
• First start the transmitter, then the model. Depending on how the flight controller is programmed, the flight control-
ler's readiness for operation is signalled by different signal sounds.
• Push the control lever for the motor function slowly from the bottom to the top position. The rotor will start up and
increase speed depending on control lever position.
• When the control lever is at the top stop, the maximum rotor speed is reached. Then move the control lever back
to the bottom-most position.
• Perform a brief motor test and check the run of the rotor.
• Disconnect the flight battery from the model and switch off the transmitter.
60
Figure 25
Figure 26