Reely SZD-54 Bedienungsanleitung Seite 52

Now, the wings can be installed in the fuselage slots on the left and right. For this, push the enclosed wing rod into the
wing. The wing rod is later secured at the bottom of the wing with one screw each with the wing pushed on. To install
the wing rod, these screws may need to be turned out a little at initial assembly.
Push the wing rod into the hole of the middle fuselage part. Insert the plug of the aileron servo into the fuselage and
plug it into the enclosed Y-cable. Always observe the correct polarity. The minus line is black or brown at the outside at
the plugs and must meet the same colour at the counterpiece. The single plug of the Y-cable must then be connected
to the receiver, slot "CH1" (only applies to the RTF version, item no. 1507960).
52
Figure 12
Figure 13