Vari RAPTOR Hydro K Bersetzung Der Originalbetriebsanleitung Seite 53
Mehrzweckträger
Verfügbare Sprachen
Verfügbare Sprachen
3.5.10.2 Storage
Before storing the machine for a longer time, we recommend to do the following:
Remove any dirt from the machine.
Repair any paint damage.
Drain the fuel from the fuel tank and carburettor (further instructions in the engine operating instructions).
Lubricate the machine as recommended, see Table 29 .
Check the tyre pressure and inflate the tyres to
of the rubber parts of the tyres.
Prevent unauthorized persons from access to the machine. Protect the machine against climatic conditions but do not use impermeable
protection to prevent excessive corrosion it may cause.
3.5.10.2.1 Machine Washing and Cleaning
When washing and cleaning the machine, proceed so as to observe valid provisions and laws regarding protection of water courses and
other water resources against pollution or contamination by chemical agents.
Never wash the engine by a water jet! During starting, the engine electric system could malfunction.
You can use the pressure washer to wash the other parts of the machine.
After washing, always dry the machine and lubricate, if needed, moving parts in accordance with instructions in Chapter
3.5.3 Machine Lubrication.
3.5.10.3 Disposal of Packaging and the Machine at the End of its Service Life
When you unpack the machine you are bound to dispose of the packaging material according to national laws and
decrees concerning waste disposal.
When disposing of the machine at the end of its service life, we recommend proceeding as follows:
1)
Demount from your machine all the parts that may still be used.
2)
Drain oil from the engine into a suitable closing container and dispose it in a waste collection centre
3)
Remove the plastic and non-ferrous metal parts.
4)
The remaining machine and its removed demounted parts are to be disposed of according to national laws and decrees
concerning waste disposal.
3.5.10.4 How to Order Spare Parts
These Operating Instruction do not include the list of spare parts.
For correct identification of your machine, you have to know the type designation (Typ), serial identification number (№) and order
number (C№) stated on the machine nameplate, box, or in the warranty card. Only with this information it is possible to search correctly for
the designation of the respective spare part with your seller.
To search spare parts in the electronic catalogue of spare parts at http://katalognd.vari.cz, the first 10 characters of the identification
number № are sufficient. If you do not have Internet access, you can ask for the printed catalogue to be sent C.O.D.
Table 39: Nameplate - example
3.6 Manufacturer's Contact Information
VARI,a.s.
Phone: (+420) 325 607 111
Opolanská 350
E-mail:
289 07 Libice nad Cidlinou
The Czech Republic
80
The respective local authority will inform you of the disposal centre location.
MAX
vari@vari.cz
Web:
http://www.vari.cz
value. Treat the tyres with a suitable preparation for protection and renovation
Field
Description
Device type designation:
Typ
RAPTOR Hydro K
Unique serial identification number:
№
1005900364.0220.00001
Business (order) number:
C№
4553
http://www.vari.cz
RAPTOR Hydro K
80
.
(product.season.sequence)
http://katalognd.vari.cz
53
