Atlantic EXPLORER Installations- Und Bedienungsanleitung Seite 93

Presentation
10.3.1.2. Coil connection
If the product coil is connected, set one of the following installation types:
In this mode, only the manual setpoint is available.
10.3.1.3. Recirculation loop
If the recirculation loop is connected, set up the product as described below:
Installation
In this mode, the setpoint
is fixed at 62 °C and the
other parameters are
no longer available.
Use Maintenance
Check that the installation
corresponds to that
described in the paragraph
"Installing the domestic hot
Warranty
water sensor".
The temperature can be set
between -5 °C and 40 °C.
Below the set temperature,
the product prioritises
operation via the boiler.
Above it, it will operate
solely via the heat pump.